Using the KVM over IP Device
From CyberWurx Customer Wiki
(Difference between revisions)
| Revision as of 16:20, 29 January 2008 (edit) Cwadmin (Talk | contribs) ← Previous diff |
Revision as of 16:21, 29 January 2008 (edit) (undo) Cwadmin (Talk | contribs) (→Step 2) Next diff → |
||
| Line 25: | Line 25: | ||
| Now you are inside your IP KVM management page. Usually you will only see one device listed here. If you have more than one you will see each one here. | Now you are inside your IP KVM management page. Usually you will only see one device listed here. If you have more than one you will see each one here. | ||
| [[Image:Kvm_LaunchPage.Png|frame|right|Figure 2.2 - KVM managment.]] | [[Image:Kvm_LaunchPage.Png|frame|right|Figure 2.2 - KVM managment.]] | ||
| + | You would simply click Launch management for access to the area. | ||
Revision as of 16:21, 29 January 2008
Contents |
Obtaining an IPKVM
If you would like an IPKVM installed on your system, write the support department.
How to Use my IPKVM
If you obtained the IPKVM function on your server here are the instructions on logging in in a few simple steps.
Before you begin, make sure you have logged into the customer center.
Step 1
Verify you have the IPKVM enabled for your account. You should see an option under Services if it is in fact enabled.
Figure 2.1 - Where to look for the kvm
The KVM will show up under services like Figure 2.1 shows.
Simply click on the IP KVM icon and proceed to step 2.
Step 2
Now you are inside your IP KVM management page. Usually you will only see one device listed here. If you have more than one you will see each one here.
Figure 2.2 - KVM managment.
You would simply click Launch management for access to the area.
